Edge Technology Pro Tram System With 1/2 Inch Shank
Description
Additional images
Send to friend
Edge Technology Pro Tram - Milling Head Setting System With 1/2 Inch Shank...
The Pro Tram by Edge Technology makes the process of tramming your mill fast, easy and accurate. Tramming is the process of squaring the head of your mill to the table. Most machinists know that if your mill is not trammed properly, surface finishes will be poor and parts will not be flat or square. Most machinists also know that conventional tramming techniques can be tedious and time consuming. The Pro Tram solves these issues allowing you to tram your mill quickly and accurately. To use the Pro Tram simply lower the unit down onto the table and adjust the head until both indicators read the same number. Repeat this process for the opposite axis and you are done. The Pro Tram is also sized perfectly to fit the bed of a 6 inch vise allowing you to tram the head to the vise instead of the table. If you want to spend less time tramming your mill and more time machining parts then you need the Pro Tram by Edge Technology.
Square the head of a milling machine quickly and easily
Simply lower unit to the table and adjust the head until both indicators read the same
Sized perfectly to fit the bed of a 6" vise allowing the head to be trammed to the vise instead of the table
Can be used with a sine bar or sine plate to adjust the head to precise angles
Calibration procedure accounts for any error introduced by worn collets
Guaranteed to be equal to or better than any other tramming method or spindle squaring device available
